Magma PCI Expansion System PE6RR Bedienungsanleitung Seite 23
- Seite / 56
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
MAGMA
Chapter 4 Install Cards and Drives 15
400W, 100-240V/6.3A, 50-60HZ Power Supply
Drive bay – used to mount up to seven (7) 3.5” internal hard drives
using 1 or 2 optional Disk Drive Cages (PN: RDRIVECAGE)
5V load resistor – to be removed if optional hard drives are installed
Installing 3
rd
Party PCI Cards
Slot ordering in PE6R4 should begin with the slot farthest away from the
power supply – labeled SLOT 4.
Generally, when installing 3
rd
Party PCI cards in the Magma expansion
chassis, it should make no difference which PCI slot you place your
cards in, unless specified by the card manufacturer.
Install PCI cards following PCI card manufacturer’s recommendations.
Some PCI card manufacturers recommend that you install their software
driver(s) prior to installing the hardware. If this is the case, you should
install their driver before you connect and power up the expansion
chassis.
Make sure that all PCI cards are fully seated in their connectors. When
correctly seated in its connector, you will notice a firm resistance when
you pull up gently on the card. To keep the cards in place, secure them
in the enclosure with their retaining screws (supplied with the Magma
expansion chassis).
IMPORTANT
The sheer number of PCI cards and device drivers available
makes it impossible for Mobility to fully test and certify all available
PCI cards for use in the Magma expansion chassis. Our best
advice to you in this regard is to insist on full PCI Specification
compliance from your card and system vendors. Cards and
systems should be at least PCI Specification Revision 2.0
compliant or better. Compliance in your system motherboard, PCI
cards, and console firmware (or BIOS) is your best assurance that
everything will install and operate smoothly.
Not all PCI cards are as "well-behaved" as they should be.
Sometimes simply moving a PCI card that is having a problem to a
different slot, or reordering your cards in their slots, will alleviate
"behavior" problems.
- Model: PE6R4 1
- Model: PE6RR 1
- Table of Contents 3
- Preface 5
- Safety Instructions 6
- Chapter 1 Introduction 9
- Pre-Installation Information 10
- Parts List 10
- Before you Begin 12
- Recheck the Installation 14
- Applying Power Correctly 15
- Shutting Down: 16
- Rack Installations 17
- Windows 18
- Mac OS X 19
- Mac OS 10.4.x 20
- Install 3 22
- Installing 3 23
- Party PCI Cards 23
- Installing Hard Drives 24
- Finishing Touches 25
- General Chassis Cleaning 26
- Cleaning the Air Filter 29
- Locate the Problem 30
- When Nothing Works 32
- My PCI Card Doesn’t Work 34
- Support for 3 35
- Windows Error Codes 36
- Contacting Technical Support 38
- Magma Debug Utility 39
- PCIScope Software Utility 40
- Appendix A Bus Hierarchy 43
- Fan-Out 46
- Verify your configuration 47
- Daisy-Chaining 48
- Workstation 49
- PCI Card Conflicts 50
- Finding the Problem Card 52
- APPENDIX C Compliance 53
- Manual P/N 09-09906-01-B2 56
Verwandte Produkte und Handbücher für Hardware Magma PCI Expansion System PE6RR
(74 Seiten)HP vc4820T Handbücher
Bedienungsanleitungen und Benutzerhandbücher für PC / Workstation Barebones HP vc4820T.
Wir stellen 1 PDF-Handbücher HP vc4820T zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Kommentare zu diesen Handbüchern