Magma UPGTB2 Installationsanleitung PDF herunterladen (Seite 16)

Magma

Thunderbolt™ 2 Interface Card | Verify Installation

FIGURE B

NOTE

LEDs D6 and D8 are illuminated when power cord is attached to expansion unit.

This means the expansion unit is on standby-mode.

If you don’t see these TWO GREEN LEDs coming ON, it means there is no power being supplied to the board. Check

J7 on the Interface card and make sure the 3-pin wire / power cable is firmly connected. If the two GEREN LEDs are

still not coming on you need to reseat the Thunderbolt™ 2 Interface card and remove & reconnect the 3-pin wire

connector to J7.

1 2 ... 11 12 13 14 15 16 17 18 19

Keine Kommentare

Magma UPGTB2 Installationsanleitung Seite 16